Comments on: MF70 CNC PCB milling https://ba0sh1.com/2013/01/01/mf70-cnc-pcb-milling/ Electronics, Computers at leisure time Sun, 20 Dec 2015 22:56:09 +0000 hourly 1 https://wordpress.org/?v=6.1.1 By: Baoshi https://ba0sh1.com/2013/01/01/mf70-cnc-pcb-milling/#comment-48 Sun, 20 Dec 2015 22:56:09 +0000 https://www.ba0sh1.com/?p=544#comment-48 In reply to John.

http://www.planet-cnc.com

]]> By: John https://ba0sh1.com/2013/01/01/mf70-cnc-pcb-milling/#comment-47 Sun, 20 Dec 2015 22:38:56 +0000 https://www.ba0sh1.com/?p=544#comment-47 Hello,

can you please tell me the USB CNC controller are you using?

Thanks,

]]> By: Baoshi https://ba0sh1.com/2013/01/01/mf70-cnc-pcb-milling/#comment-46 Sun, 30 Mar 2014 13:50:11 +0000 https://www.ba0sh1.com/?p=544#comment-46 In reply to hannes.

Hi,

The tool sensor is from China. It is not as useful as it looks, a piece of PCB material is good enough for the job.
The software is from http://www.planet-cnc.com

]]> By: hannes https://ba0sh1.com/2013/01/01/mf70-cnc-pcb-milling/#comment-45 Wed, 26 Mar 2014 12:02:08 +0000 https://www.ba0sh1.com/?p=544#comment-45 Hi,

where did you get the tool sensor for measuring z-axis offset? And what software did you use for usb cnc controller?

Best regards

]]>