Comments on: Minimalism AVR development board https://ba0sh1.com/2014/10/15/minimalism-avr-development-board/ Electronics, Computers at leisure time Fri, 17 Oct 2014 08:38:17 +0000 hourly 1 https://wordpress.org/?v=6.1.1 By: Minimalism AVR development board | Tehnik Service https://ba0sh1.com/2014/10/15/minimalism-avr-development-board/#comment-150 Fri, 17 Oct 2014 08:38:17 +0000 https://www.ba0sh1.com/?p=1000#comment-150 […] Source: ba0sh1 […]

]]> By: Baoshi https://ba0sh1.com/2014/10/15/minimalism-avr-development-board/#comment-149 Thu, 16 Oct 2014 00:29:14 +0000 https://www.ba0sh1.com/?p=1000#comment-149 In reply to Ralph Doncaster.

Good idea! Saves two hole on the breadboard too.

]]> By: Ralph Doncaster https://ba0sh1.com/2014/10/15/minimalism-avr-development-board/#comment-148 Wed, 15 Oct 2014 23:52:27 +0000 https://www.ba0sh1.com/?p=1000#comment-148 Nice work!
Looks like you could use the pads above pin1 and pin20 of the 2313 to solder a 0805 .1uf decoupling cap. Then you could easily wire those to Vcc & Gnd.

]]>